Description
Flexible, bitumen rubber emulsion based, one component, solvent free waterproofing material
Field of Application
• Waterproofing of sub-base building structure surfaces (horizontal/vertical) which are permanently contact with leakaging or pressurized water andmoisture.
• Waterproofing of foundations, retaining walls and basement walls, green terraces, sub-base car parking areas, basement floors.
• Waterproofing of wet areas like bathrooms, WC etc.
• Waterproofing of balconies and terraces (under floor covering).
• Waterproofing of interior and exterior mineral surfaces like concrete, stone, brick, plaster, mortar etc.
• Adhesion of polystyrene heat insulation panels.
Properties
• Easy to apply (by brush, trowel or airless spray) on both vertical and horizontal surfaces.
• Highly adherent to any mineral substrate.
• Flexible and crack-bridging.
• Forms a seamless moisture and waterproofing membrane.
• Resistant to aging under the conditions that is exposed, like various salt solutions, chemicals in regular soil. weak acids. Performance will be saved for several years.
• Resistant to 7 bar water pressure at 4 mm thickness.
• Pot life is long and application cures fast.
• Resistant to freeze-thaw cycles.
• Suitable for areas and surfaces where vibration or motion is present.
• Can be used on brick walls without plastering.
• Water based, not harmful to the environment.
Warnings
• Any addition including water is not allowed unless except using as a primer.
• Application apparatus should be washed with water immediately after the application.
• Backfilling must be done, after Concoat FB has cured completely.
• Protect the applied surface from sun light, rain for min. 24 hours and from frost from 3 days.
• Do not inhale the powder, because it is a cement-based material. Wear suitable glover and eye protection. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. After contact with skin, wash immediately with plenty of water and soap.
• Not applicable on the metal surfaces without primer.
• More detailed information is available in MSDS.
Storage
Product should be protected from freezing.
Packaging
17 ltrs. plasticpail.
How to Use
• The surface must be free of loose parts, dust, dirt, oil and etc. which may cause poor adhesion.
• Apply on dry or damp (but not wet) surfaces. Do not apply during rainy weather.
• Cracks and holes on the substrate must be repaired by Conset 45 T & C.
• In order to prevent air bubbles that may occur during or just after the application on highly porous surfaces, pores should be treated by Conset 45 T & C or Concoat FB.
• For improved adhesion on the surface; diluted Concoat FB in the proportion of 1/3-1/5 by water should be used a primer.
• To reinforce the waterproofing membrance on large areas, horizontal and vertical corners and to bridge the existing cracks, apply with fibre mesh of 70-90 g/m2. In waterproofing of foundation and sub-base retaining walls, protect the applied surface with suitable brick, drainage or insulation boards.
• Concoat FB should be mixed by a max. 500 rpm mixer before application. The product is ready-to- use. Any additon including water is not allowed unless except using as a primer.
• After the primer has dried, apply min. 2 coats with brush or trowel. Wait for 1-2 hours depending on temperature between coats.
• Prepared mixer should be used within 3 hours. Dispose mixture of which pot life is expired. Right after the application clean tools and hands with water.
• According to the surface porosity and water pressure, more coats can be applied.
